The maximum temperature at which a component is designed to run for sustained periods.
The recommended temperature of a device during its operation.
Indicates the temperature at which a device can safely and effectively work.
The temperature range over which an LED is designed to operate safely.
The operating temperature is the predetermined actuation value at which a bimetallic temperature switch closes or opens the electrical circuit. In general, the operating temperature of a unit must be within the range indicated in the data sheet and must not be above or below this range.
The nominal temperature that the rupture disc is exposed to during normal operation.
The nominal temperature which the bursting disc is exposed to during normal operation
The temperature range which the device has been designed to operate.
The temperature range over which the oscillator will operate within its specifications.
The range in temperatures over which an instrument can be. It is often the case that the performance of the instrument will degrade as the temperature changes from ambient to the extremes. This degradation in performance is sometimes called ambient derating. The specifications for an instrument usually refer to operation at ambient temperature (25 C or 70 F).
The range of ambient temperature in which a controller is designed to operate within its specifications. May be stated in Fahrenheit of Celsius.
The temperature range through which a UPS can sustain normal operations (typically 0 - 40 C).
The range of temperatures within which equipment will perform within specified limits.
The temperature range in which a tape will perform once it has been applied to a surface.
The maximum internal temperature at which a system, harness, or connector may operate in continuous service, generally expressed as a time and temperature.
The heat sink temperature at which the diode laser characteristics were measured.
Range of ambient temperatures within which a power supply can be safely operated.
actual range over which sensors can be operated. Usage outside the temperature limits will result in loss of stability, change in operate point and possible permanent damage to the sensor. Nominal sensing distance is determined at 25 - C.
(Thermostats) Temperature at which normally closed contacts open or normally open contacts close.
The manufacturer's recommended feedwater or inlet water temperature for a water treatment system.
A measured relubrication interval can be achieved within given limits. The lubricant should be sufficiently thermally stable at the upper operating temperature and should not be too thick at the lower operating temperature.
The steady state temperature at the contact, e.g. the bearing position that levels off while the machine is in operation.