1). In the folder, the thin, sharp points of metal which pull the web into the folder, located just before the cut-off knives. 2) In stripping, small metal devices used to secure two pieces of film or a piece of film and a plate to each other for registration purposes.
Pins are used for temporary basting of fabric. They are used to hold patterns in place while cutting and to hold fabrics together while stitching (it is not recommended to machine sew over pins as they have been known to break your sewing machine needle, jam the machine, or cause other problems). Often, large safety pins are used to baste quilt layers before the final quilting. Care should be taken to use a pin that will not leave a large hole and to not leave pins in fabric too long; they could cause stains where they touch the fabric.
The thin metal rods that are inserted through holes in the upright supports which fasten the supports to the basket
A pin is a device used for fastening objects or material together. It is usually made of steel, and is formed by drawing out a thin wire, sharpening the tip, and adding a head. History of the pin: The Sumerians used pins made of iron or bone to hold fabric together as early as 3000 BC. In medieval times, during the reign of Henry VIII, a law was passed prohibiting the sale of pins except on certain days. Although meant to alleviate the scarcity of pins, the law made the problem worse and was repealed a few years later.
Jewelry attached to clothing by means of a small metal rod with a sharp point.
Pins are charm-like legacy jewelry typically worn on clothing.
In the context of this book, pins or small nails are used to hold small pieces of veneer together. Use small brass or stainless steel pins.
The most common method for holding your fabric in place.
Metal pins that are fastened to your layout. It can be personal memorabilia or safety pins that hold a small charm.
Related Topics: [ surveying] [ distance] [ area] [ volume] A set of 11 metal pins, each about 1 ft. in length, and their holding ring: Used by a two-person taping crew: the front crew member inserts a pin at each new point (usually every 100 ft.); the rear crew member will subsequently remove the previously set pin; they then proceed forward for the next tape increment. When the head crew member has inserted the 11-th pin, the rear member will pull the 10-th pin. 1000 ft. have been traversed. The 10 pins are carried forward and the process resumes.
metal pieces used to hold a pocket knife's parts together. They are usually made of brass or nickel silver. Click here for illustration
Short pieces of metal on a cable or connector that connect to holes on the female connector to establish a physical connection between two components.